Cafe-Med.net

How to buy geothermal floor?

 
Poster un nouveau sujet   Répondre au sujet    Cafe-Med.net Index du Forum -> Pour Les Nouveaux Membres -> Règles Générales
Sujet précédent :: Sujet suivant  
Auteur Message
happywork
ForuManiac
ForuManiac

Hors ligne

Inscrit le: 25 Aoû 2016
Messages: 1 316

MessagePosté le: 03/12/2016 08:04:00    Sujet du message: How to buy geothermal floor? Répondre en citant


To be used as floor heating, to be E0-class standards, that is, the average amount of formaldehyde emission is less than 1.5mg / l. As for the floor temperature is to speed up the release of formaldehyde doubt, has been done related experiments to warm water coil,reviews of wood like floors the water temperature in accordance with national standards should be at 55 degrees, and through the pipe to the filling layer of the transfer temperature to Wood floor, mostly less than 30 degrees, and this temperature is the wood floor structure will not change, from the floor than the Gejia special laboratory structure, the formaldehyde content was not significantly increased. From the people's experience, the summer a lot of indoor temperature is also more than 30 degrees. Therefore, whether the formaldehyde and geothermal is not directly related.

 
<PThe thicker the wood floor, the more insulation it?

 

The thickness of wood flooring is to determine whether the foot feel comfortable factors, so many consumers in the purchase of the floor, especially the purchase of solid wood, multi-layer solid wood flooring or bamboo flooring requirements of the thickness of 15-18mm. Floor heating, they also use this method to pick, but not knowing that wood is a poor conductor, usually wood material thermal conductivity between 0.17-0.34,wood plastic composite pergola installer in sydney and water to 0.5. If the floor thickness is too thick, even more detrimental to heat through The floor conduction to the board up, and are consumed in the conduction process. As for insulation, the floor temperature difference between the upper and lower floor is bound to lead to great deformation, "thermal expansion and contraction", "wet expansion shrinkage" will cause floor scoop, twist, bending, crack, dimensional stability can not be guaranteed (geothermal floor Suitable thickness 8-12mm).

 
<PCan I add plywood or blockboard under the floor?

 
<PFirst, the geothermal heating floor laying plywood or blockboard, is not conducive to the conduction of heat, virtually in the conduction process of heat and increase the loss, an increase of geothermal heating system heating costs. Secondly, if the quality of these boards do not pass, will lead to excessive indoor formaldehyde content, or because of its moisture content is not up to the standard, after the laying of water absorbed by the floor, resulting in floor tile change, arching phenomena, This substrate is more harm than good, can be described as self-defeating, superfluous! More not allow the floor bedding shop treasure.

 

In the floor above the combination of non-leg combination of furniture or carpet, etc., will not damage the floor cooling surface?

 

With the continuous improvement of modern living standards, people are more and more for the pursuit of individual home decoration, so it came into being a number of personalized assembly of furniture, which can be assembled according to the owner's preferences. However, these furniture are often direct contact with the ground floor of the legless furniture. If the indoor pavement is geothermal heating floor, its furniture,decking materials in northern ireland carpet and floor cover a large area directly, will make the floor here due to heat can not be dispersed, excessive concentration caused by uneven floor heating, resulting in deformation of the floor here, etc. , A waste of heat, so that room temperature chat low.
Revenir en haut
Publicité






MessagePosté le: 03/12/2016 08:04:00    Sujet du message: Publicité

PublicitéSupprimer les publicités ?
Revenir en haut
Montrer les messages depuis:   
Poster un nouveau sujet   Répondre au sujet    Cafe-Med.net Index du Forum -> Pour Les Nouveaux Membres -> Règles Générales Toutes les heures sont au format GMT
Page 1 sur 1

 
Sauter vers:  

Index | Panneau d’administration | Créer un forum | Forum gratuit d’entraide | Annuaire des forums gratuits | Signaler une violation | Conditions générales d'utilisation
Powered by phpBB © 2001, 2017 phpBB Group
Traduction par : phpBB-fr.com