Cafe-Med.net

Wood flooring local drum deformation of the how to do?

 
Poster un nouveau sujet   Répondre au sujet    Cafe-Med.net Index du Forum -> Pour Les Nouveaux Membres -> Règles Générales
Sujet précédent :: Sujet suivant  
Auteur Message
happywork
Très Bavard
Très Bavard

Hors ligne

Inscrit le: 25 Aoû 2016
Messages: 511

MessagePosté le: 18/11/2016 08:28:46    Sujet du message: Wood flooring local drum deformation of the how to do? Répondre en citant


Some owners complained that just paved good wood flooring, not a few months, a significant part of the floor from the arch phenomenon, a serious impact on the beauty of the room and use. In the end is what causes the wooden floor partial arch deformation? How should we prevent it?


Wood flooring local drum distortion of the reasons:


(1) the surface layer of wood flooring moisture content is high or low. High, dry wood flooring in the air will lose moisture,polyethylene for wpc section contraction, and warping deformation, low wood floor shop after the absorption of air moisture, resulting in arch.

<P(2) wood joists between the filling of fine stone concrete or insulation materials are not dry, the floor laying, the absorption of moisture after the drum, deformation.


(3) no moisture layer or floor around the floor to stay vent holes, after laying the surface layer of moisture can not be discharged in time.


(4) wool flooring at the end of the gap or gap is too small, damp expansion, the surface layer from the drum, deformation.


How to prevent water from the local floor drum, deformation?
(1) control the moisture content of wood flooring,spain foam pvc plastic the moisture content should not be greater than 12%.


(2) wood joists between the fine stone concrete or insulation sound insulation materials, must be dry before laying the floor.


(3) a reasonable set of ventilation holes. Wood joists should be the same hole slot, and the floor surface layer connected to the ventilation hole, the floor surface layer ventilation holes each not less than two, each side of the skirting board ventilation holes not less than two, ventilation holes should be kept unimpeded to facilitate Air circulation.


(4) wood floor board (that is, the floor of the floor), the slit should be properly opened, usually 2 ~ 5mm, the surface should be planed,composite deck companies in dade county florida the adjacent slit should be staggered around the wall about 10 ~ 15mm.


(5) between the board surface and the wall should be left 1Omm gap, with a skirting board or Kick bar cover.
Revenir en haut
Publicité






MessagePosté le: 18/11/2016 08:28:46    Sujet du message: Publicité

PublicitéSupprimer les publicités ?
Revenir en haut
Montrer les messages depuis:   
Poster un nouveau sujet   Répondre au sujet    Cafe-Med.net Index du Forum -> Pour Les Nouveaux Membres -> Règles Générales Toutes les heures sont au format GMT
Page 1 sur 1

 
Sauter vers:  

Index | Panneau d’administration | Créer un forum | Forum gratuit d’entraide | Annuaire des forums gratuits | Signaler une violation | Conditions générales d'utilisation
Powered by phpBB © 2001, 2015 phpBB Group
Traduction par : phpBB-fr.com